Compatible with Sony a6000, a6300 and a6500
cameras.*When the walkie-talkie picks up the a6500, the camera's C1/C2 buttons cannot be used.
.
* MDX-?6300 handsets with the following serial numbers (last four digits) are compatible with all of the above cameras;
Black: 0020 - 0028 and higher 0037
Orange: 0004, 0005, 0009 and 0010
Light blue: ¨above 0004
* MDX-a6300 housings¨use with serial numbers other than the above are compatible with a6000 and a6300 cameras only.
Improved underwater weight
.The weight of the MDX-a6300 is approximately the same as that of the MDX-a6000. However, the underwater weight has been improved by redesigning the key components and precision machining.
SA8 accessories can be attached
.The MDX-a6300 is compatible with SA8 accessories, making it a compact, high-quality system
.Two ergonomic thumb rests on the rear walker
.When the SA8 rail and handles are not in use, the two ergonomic thumb rests can be used to securely grip the walker
.ML hand strap can be attached
.The ML Hand Strap is recommended when no rail or grip is used. With the ML hand strap, you can grip the walker securely with one hand
.The walker features two accessory ports
.One port can be used with the optional N-type lightning connector (two pins). The other port can be used with the optional leakage wächter (vacuum system). The 5-pin sync cable/N can be used when a flash (e.g., YS-D2) is connected to the housing, allowing for precise rapid flash discharge.
LCD monitor hood with lens can be mounted
.The hood reduces reflections and provides a clear and full view of the camera's LCD screen
.Additional Features
- All camera functions can be used underwater.
- Equipped with two fiber optic cable jacks.
- Equipped with a lens release button.
- The port lock can be activated from the outside of the housing.
- Powerful luminescent buttons. Controls glow in low light conditions.
- The camera's built-in flash can be activated and deactivated from the walk üuse via the built-in flash cancel button and flash lock lever.
- Optional leak sensor can be built into the housing. The LED light is located in the LCD monitor window.
- Using the hand strap is recommended when not using a camera rail . The hand strap helps you hold the go use with only one hand.
- Equipped with two sacrificial zinc diodes (one on the front go use and the second on the Rück side) to prevent electrolytic shock.
Body Material: | aluminum |
---|---|
Camera System: | Mirrorless (MIL) |
Camera manufacturer: | Sony |
Strobe connector: | optical Sea&Sea |
- Housing material: corrosion-resistant aluminum alloy
- Nominal depth: 75m
- Dimensions (WxHxD): 195 x 125 x 100 mm
- Weight: approx. 1,265 g (housing only)
- Underwater housing MDX-a6300 for Sony A6000/A6300/A6500 by Sea&Sea
- O-ring grease
- O-ring remover
- Button rubber(large) x 8
- Wheel rubber (large)
- Inbus wrench
- Hood rail top
- Cap rail bottom
- Cap screw x4
- Cap stopper
- O-ring care instructions
- Operating instructions
Only the components of the item that are listed here will be delivered. Accessories and/or decoration shown in our images are for demonstration purposes only. In particular, we would like to point out that the purchase of an underwater housing does not include a camera and often not a port nor an external viewfinder. If you have any questions about the configuration of your system, do not hesitate to contact us.
Login