Manueller Blitzauslöser für Canon und Nikon

Its superior ergonomic design and standout range of optional accessories help you capture those optimal moments with the best image Quality. Much lighter than previous housings. Using unprecedented precision machining, the dimensions of the housing are similar to those of the camera. In addition, the revised internal design has also helped reduce weight. The MDX-D850 is approximately 11% (350g/12.3oz) lighter than the previous MDX-D810 housing. All the dials have a spring (damper) to prevent slip of the controls All the dials have a spring (damper) to prevent slip of the controls even if the dimensions of the cameras are slightly different or even if gears or other parts wear out to some extent.  Leak Alarm Unit as standard equipment The Leak Alarm Unit, which was previously available as an option, is now included as standard equipment. It is effective not only for early detection of underwater flooding accidents, but also for protection of equipment by checking its waterproof performance before entry. CR2032 lithium battery included. Optical YS Converter/N1 can be built into the housing Optical YS Converter/N1 can be built into the housing Compatible with Optical YS Converter/N1 for MDX housing which converts the camera’s hot-shoeTTL signal to a light signal. Both TTL and manual strobe modes can be used and controlled from the housing using a Fiber-Optic Cable II. * Fiber-Optic Cable ll is required when using the Optical YS Converter. * Serial numbers 124000274 and above are compatible with the Nikon D850. Serial numbers below 124000274 are not compatible. New firmware and/or conversion of the converter will be required. Other Features The Port Lock prevents the port from turning or loosening and the Port Lock lever is specifically located to avoid being unlocked accidentally. The housing is equipped with a lens-lock release button which makes it possible to change lenses easily, without opening the housing. The camera’s diopter adjustment dial can be operated from outside the housing. This feature is useful when two or more people with different eyesight use the housing. Pulling out the Focus/Zoom Dial gives sufficient room inside the housing to easily accommodate larger diameter lenses. All controls have luminescence stickers which glow in dark environment. Equipped with the Optical Viewfinder 0.5x as standard. Other optional viewfinders such as the VF180 1.2x, VF45 1.2x and Optical Viewfinder 0.8x can be used. *When the VF180 1.2x is mounted on the MDX-D850 housing, the lower part of the camera's viewfinder (where the shooting data is displayed) cannot be viewed due to vignetting. Sync Cord 2-pin Connector enables use of conventional hardwired Sync cable (Manual mode only). Accessory port enables use of Leak Sentinel (vacuum sensor). Equipped with two sacrificial zinc diodes (one on the front case and the other on the rear) to prevent electrolysis damage. Built-in leak sensor immediately alerts you to water ingress. Tripod screw mount is located on the centre underside of the housing.

Most modern Sea&sea underwater housing MDX-R for mirrorless full-frame camera Canon EOS R. Compact, compatible with YS optical converter and ergonomically designed. The Port Lock prevents the port from rotating or loosening, and the Port Lock lever is specially positioned to prevent accidental unlocking. The housing is equipped with a lens release button that allows for easy lens changes without having to öopen the housing. Pulling out the focus/zoom wheel provides enough space inside the housing to easily accommodate larger diameter lenses. All controls have luminescent decals that glow in dark environments. Fitted with the 0.5x optical viewfinder as standard. Other optional viewfinders such as the 0.66x and 0.8x optical viewfinders can be used. When the VF45 and VF180 1.2x are mounted on the housing, the corners of the camera's viewfinder cannot be viewed due to vignetting. The 2-pin sync cable connector allows the use of a conventional hard-wired sync cable (only in manual mode). Equipped with two sacrificial zinc diodes (one on the front and the other on the Rück side) to prevent electrolytic damage. Equipped with an underbody protector to protect against scratches. Designed to be compact and lightweight. The housingsäuse been developed according to the advantages of the compact design and light weight of the mirrorless camera to improve these characteristics. Compared to the SLR MDX-5D Mark lV camera body, the MDX-R is 100g/ lighter on land.  Connectors and gears for the MDX series SLR housings can be used. The MDX-R is compatible with the MDX series SLR housing port system. With the mounting adapter and ports/gears for the MDX series housings, you can use EF lenses. Compatible with YS optical converter C/R. TTL flash mode possible. The new optional YS optical converter C/R*, which converts the camera's TTL signal into an LED light signal, is available. With the converter, both TTL and manual exposure adjustment is possible. Developed for RF mount lenses. The focus/zoom wheel has two gears, one of which is designed for RF-mount lenses.